Reduce CO cylinders to HZ - Digital Cylinder AX (Z5) Modularity

You can use a special centre piece to assemble a half cylinder from an AX comfort cylinder or a freely rotating cylinder.

  1. Extractor for releasing the clamp
  2. Spacer for aligning the extension bolt
  3. Clamp block for pressing in the clamp
  4. Half Cylinder Center Section
  1. Place the Cylinder AX in the thumb-turn assembly tool with the electronic thumb-turn facing upwards.
  3. Hook the tip of the extractor into the clamp.
  5. Lever the clamp out of the profile cylinder by moving the extractor to the centre of the cylinder.
  7. Pull the clamp completely out of the profile cylinder.
  9. Disassemble the two cylinder halves.
  11. First cylinder half prepared without centre piece.
  13. Place the spacer on the half-cylinder centre piece.
  15. Screw in a suitable extension bolt with the extractor until it rests on the spacer.
  17. Place the prepared cylinder half in the thumb-turn assembly tool.
  19. Place the half cylinder centre piece on the prepared cylinder half.
  21. Extension bolt is protected against twisting.
  22. Pull the spacer off again.
  24. Push the cylinder parts together completely.
  26. Refit the clip into the slot of the profile cylinder with the lug facing the fastening screw.
  28. Insert the cylinder into the clamping block so that the profile cylinder and the thumb-turn lie flush in the recesses.
  30. The lever of the clamping block is reinforced at one point with a metal plate. The bracket that was previously inserted lies opposite this metal plate.
  31. Push the clamp block lever towards the base plate until the clamp is fully seated in the profile cylinder.
  1. Half cylinder AX is fully assembled.