Buttons - Transponder terminal

Event button

The event button is located on the right-hand side of the transponder terminal housing. It is used to start the programming process or to start communication between the transponder terminal and the programming software via the IP network.

Power-up reset button

The power-up reset button is located on the underside of the housing. This can be used to briefly interrupt the power supply. The device then performs a restart. This is recommended if the device "hangs" or if the terminal does not continue with the programming steps after a short time when using the event button. However, all steps under Operation must have been completed beforehand. If programming does not start, this may be due to a problem with the network or there are no programming tasks in the LSM. If in doubt, contact the locking system administrator of the locking system.

Factory default reset button

The factory default reset button is located on the back of the housing and can only be used during installation. This is only used to restore the factory default settings in the event of an incorrect configuration. Caution: Pressing the button always results in the device having to be reconfigured. This may not be possible on site during installation!