Programming with LSM STARTER - MK.CD.Starter.G2

The current version of LSM 3.2 or higher must be installed on your computer. Connect the USB config device. Place the components to be programmed at a distance of 10-30 cm from the programming device and implement the programming routines.

If you should receive an error message stating that no hardware has been found, first check that the USB config device is connected properly and then verify whether the CDStarter has been detected under 'Programming / Config device' in the software. If there is still an error message, remove the programming device from the USB socket and plug it in again. The driver will then be reloaded.